Bug Tracking / Changes

Want to report a bug or submit a request? Please do so at the MU2 support forums at X-Pilot.com

Issues Since 2.0.2 release

[FIXD] ---- GPU showing in air. Code to manage GPU is wrong place. Fixed.
[FIXD] ---- Copilot HSI not animated properly. Unconnected datarefs. Fixed.
[FIXD] ---- Ignition Key 3D collision with other geometry.
[FIXD] ---- Throttle Lift Command. When hardware throttles are in lift zone, executing command to lift levers will cause 3D levers to move to match the hardware position. 3D Levers did not previously move to match hardware unless the hardware levers were moved. This was awkward for users who prefer to move their hardware throttle full aft and then execute the lift levers command for full reverse, but the levers would not move unless they "bumped/nudged" their levers. For this example case, you would simply set your lower lift zone limit to 0 and the 3D levers will move when you execute the lift command.
[FIXD] ---- Small bug where, with LEGACY throttle behavior, the power levers would lift when pulling the levers back to Flight Idle in ALPHA mode.
[FIXD] ---- Pressing SBY button on FD mode panel cancels all other FD modes and will also extinguish when any valid FD mode is active.
[FIXD] ---- NAV/APR mode not engaging with LOCALIZER only signal.

[CNG] ---- Changed the command to lift both power levers to now be two commands, one for single throttle hardware and another for dual throttle hardware
[CNG] ---- Per SPZ-500 operation, autopilot can now only be disengaged by red AP disco button on yoke. AP button between seats only engages AP.
[CNG] ---- Per SPZ-500 operation, rotating the pitch wheel on the AP controller will cancel IAS or VS modes if they are active.

[ADD] ---- Prefs to place/remove pitot covers, intake covers and chocks only available when aircraft is stopped.
[ADD] ---- Flight Director (FD) mode control panel wired up to FD DC fuse / LH feeder 2 DC bus. (annunciators driven by DC)
[ADD] ---- Support for Reality XP GTN 650/750. See setup docs here
[ADD] ---- Support for Reality XP GNS 430/530. See setup docs here
[ADD] ---- Documentation for Autopilot Usage. See docs here
[ADD] ---- Added Altitude Alert Annunciator light on the Altimeter. See SPZ-500 docs Encoding Altimeter for more info.